MEDIA PRESENCE

What are the measures to be taken for ELECTRIC WIRING?


  • The electric wiring must be performed by a specialized electrician fully respecting current standards and  legislation in force.
  • Check that the power supply corresponds to the voltage requested by the hood, which is given on the label stuck inside the hood. Ensure that the wiring system conforms to current standards and the earth discharge works efficiently.
  • Pay special attention to the hood power cable, ensure that it does not pass through any holes without a cable clamp.
  • For direct connection to the electrical mains is necessary to provide a device that ensures disconnection from the electrical mains, with an opening distance of the contacts that allows the complete disconnection under the conditions of overvoltage category III, in accordance with the rules of installation.
  • The plug or omnipolar switch must be accessible when the unit is installed If the power cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. The cable used must be of type H05VV-F 3 x 0.75 mm2 minimum cross-section.
  • The manufacturer declines all responsibility if the current accident prevention standards in force are not respected, which are needed for the wiring system to operate correctly.